Additional Materials:

Glass Bead Strand

About this Project

Put your best beads forward with this stunning slide necklace from the A.C. Moore Craftologists.



Create your own, snap a picture, and share using #ACMooreInspired

  • 1

    Lay out chain next to ruler to the 18” mark. Fold chain in half and then cut one side. This will give you a chain length of 36”.

  • 2

    Use the bead reamer to make the hole in the glass bead larger. Slide the bead onto the ends of the chains so that a large loop is formed and the two ends dangle out the other side. Trim the ends of the chain to preferred length.

  • 3
    Use pliers to open one end of the eye pin and put a Swarovski bead onto the wire. Close end of the eye pin. Place beads on the other side of the eye pin.
  • 4
    Slide one end of the chain onto the eye pin. Trim the eye pin and then use nose pliers to make a loop closure.
  • 5
    Repeat steps 3 and 4 to complete your necklace!